Where is the Viper valet switch located?

Where is the Viper valet switch located?

Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.

What is the valet button on Viper remote?

The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode.

What is valet mode?

Valet mode is a safety convenience feature standard on all Arctic Start remote start and security systems. Valet mode disables all system features other than lock or unlock; such as, remote start, alarm triggers, and trunk release.

How do I reset my Viper car alarm?

If you want to reset your Viper alarm, you can do so with your car’s fob key.

1. Point the fob key toward your vehicle as the alarm sounds.
2. Listen and wait for your alarm to sound for six seconds. Press the lock button on your key. Your vehicle’s Viper alarm will reset but the alarm will still be armed.

What does valet mode do?

Valet mode disables all system features other than lock or unlock; such as, remote start, alarm triggers, and trunk release. Valet mode can be temporarily activated to prevent unintended use of the system’s many features.

How do you put code alarm in valet mode?

To by-pass the alarm system:

1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the ON position.
3. Within 10 seconds, press and release the valet push button switch. The alarm system will stop sounding and enter the (by-passed) mode. You can now start and operate the vehicle normally.

Does valet mode limit speed?

When you activate Tesla Valet Mode, the vehicle’s operating system initiates several restrictions on the vehicle. It limits the speed to 70 mph and cap acceleration to 25% and prevents enabling Autopilot.

How do you know if your car is in valet mode?

1. Hold down the brake.
2. Cycle the vehicle key in the ignition between the ‘On’ and ‘Off’ positions 5 times.
3. Do not touch anything on the remote.
4. You will know that you have entered valet mode if you see the parking lights flash one time and/or you hear a faint click from within the dash.

How do I put my Viper alarm system in valet mode?

open the door and leave it open turn the ignition on and then back off press and hold the valet button for 5 seconds until you hear a chirp then release it. Then press and release the valet button 2 more times (quickly) then press the valet button a third time and hold it until you hear 2 beeps.

Is Viper a good alarm system?

A Viper car alarm is just the security you need for you car. Car theft is a major problem in the United States. Your car is absolutely at risk of being stolen if you do not have a good security system. Viper alarms are equipped with the latest technology so that you can relax and bid goodbye to your worries.

What does it mean setting a valet car alarm?

The valet mode on a car alarm allows someone else to drive your car without having access to the security system. Valet mode is typically employed when you’re having your car parked or serviced. It enables you to maintain possession of your security remote. Locate the push button switch on your vehicle.

What is valet mode in car alarm?

Valet mode is typically activated either by a button on the key chain transmitter or by manually disarming the alarm system from within the car using the alarm system’s valet switch. Once valet mode is established, the car’s alarm ceases to work; however, the remote door locks and panic button are still operational.